NEW SCM MODEL SANDYA 1S SINGLE BELT COMBINED ROLLER PAD SANDER
SANDYA 1-S
Automatic wide belt sanders
  STANDARD EQUIPMENT
* control panel
* powered adjustment of working thickness
* digital readout of working thickness
* natural rubber feed belt
* floating rubber-coated pressure rollers in the front/rear side of the
operating groups
* infeed flexible steel pressure plate on first operating group
* electronic oscillating of sanding belts
* dust extraction outlets with a shape which assures a low air consumption
* "Hand-safety" emergency device in the infeed panel area
* front and rear emergency pushbutton
* padlockable main switch
* direct start of main motor
* overload protection on main motor
* automatic brake for rapid shutdown of operating groups
* automatic emergency stop machine for:
- sanding belt breaking
- not-tensioned sanding belt
- lateral outplacement of sanding belt
- absence of compressed air
- overload on main motor
* motors in isolation class IP54
TECHNICAL FEATURES:
- working width 950 mm
- min./max. working thickness 4-170 mm
- sanding belt width 970 mm
- sanding belt length 1525 mm
- main motor power 5,5 (7,5) kW(hp)
- feed belt motor power 0,3/0,55 (0,4/0,7) kW (hp)
- feed belt speed 4,5-9 m/min
N.B. Cost-free executions of any voltage except 230/220 volts or lowers
SANDYA 1-S
Automatic wide belt sanders
BASIC MACHINE SELECTION
BASIC MACHINE SELECTION
05.11.30 | 1/S CS 95 * Automatic Wide Belt Sander |
| |
* SINGLE COMBINED UNIT "CS" equipped with:
- 'CR/120' roller, 120 mm diameter
- 85 SH rubber coated roller
- manual adjustment of working height
- 'TRP/I' flat stiff pad made of an extractable bar with
felt contact insert density D=0,68
- manual adjustment of working height
- glued graphite cloth
SECURITY EXECUTIONS
50.01.37 | European safety regulations (CE norms) |
|
|
A anti-kickback workpieces safety device is included
N.B. automatic star-delta start on main motor is
Compulsory
31.21.90 | “CRA” Helicoidal grooved steel calibrating roller |
| --- |
33.31.53 | 2 infeed support rollers and two outfeed support rollers |
|
|
97.11.77 | Main motor 11 kW (15 hp) |
|
|
93.01.12 | Automatic start-delta-start on main motor |
|
|
96.06.70 | Electronic positioning for working table |
|
|
It is equipped with decimal adjustment to pre-set higher or lower workpiece positioning.
The worktable fall and rise is activated by a sensor and a microswitch located near the gauge.
On/off selectors allow to disactivate this device in order to carry out the thickness set up by means of fall/rise worktable pushbuttons
25.14.40 | “TSP/I” Semi-stiff flat pad |
|
|
for the sanding of veneered panels
The pad is made of an extractable bar with rubber contact insert + felt density D=0,68
N.B. It must be linked to the automatic pad
intervention
32.18.42 | Automatic anti-dubbing device |
|
|
synchronized with both feed belt speed. With this device, it is compulsory to select the semi-stiff or elastic sectional pad.
N.B. - on/off pneumatic selector for the pad is
already included
| TOTAL PRICE TO ABOVE SPECIFICATION | CALL |
|
| 